Instructions for the Installation of Stainless Steel Strips

Instructions for the Installation of Stainless Steel Strips - for the Protection from Birds

For to avoid the landing of birds, the strips should be tightened in about 10cm above the protected object.

For to prevent the underflying of the installation by birds, the string holders type X-TRA should be installated along the borders of the object (maximum distance to the border =5cm)

In this way, the strips are tightened on two levels which makes it impossible for the birds to fly or land under the strips.

The distance between string holders must not be more than 1.5m.

Fasten the spring in the bore of the string holder. Than make an ear with the string - fasten the ear with a clamping device and fasten the ear on the spring. Tighten the string up to the last string holder and fasten the string on the holder by using the string tensioner.

Installation of Stainless Steel Strings - for the protection against birds.

MOUNTING ACCESSORIES

Bird Spikes and Nets - mounting accessories

Fastening Plates

stainless steel - material no. 1.4401 - dimensions : 20 x 40 x 0,65mm - equipped with two reinforcing creases and and bore for screwing - packaging : 100 pieces per packaging unit - screws and suitable dowels are available.
Article no. 13401

Bird Spikes and Nets - mounting accessories

Silicone Bonding Agent

Cartridge - charge =310ml - on Enquiry with pistol for the cartridge
Article no. 13414

ACCESSORIES for STRING HOLDERS and PROTECTION NETS
	Strings stainless steel - material no. 1.4401, diameter a) =0,54mm Article no. 13201, b) =1,0mm Article no. 13205, c) =1,5mm Article no. 13211, d) =2,0mm Article no. 0000 available on bobbins (1000m / other lenthes on Enquiry) - diameter 1,5mm. Also suitable for reinforcing of stainless steel and PERLON nets. special manufacturing on Enquiry.
	Clamping Device aluminium sleeves - suitable for all string types - packaging : 1000 sleeves per packaging unit
	Springs stainless steel - material no. 1.4310 - suitable for all string types - packaging : 500 springs per packaging unit
	String Tensioner stainless steel - material no. 1.4310 - also available as single piece Article no. 13407
	Clamping Rings (aluminium) - packaging : 2500 rings per packaging unit Article no. 13410 Pliers for Clamping Rings available as single piece Article no. 13411

For further information, please contact :

Mr. Jacob v. Bremen	Phone : +49 30 789 039 42
	Fax : +49 30 789 03990
	e-mail : info@rotec-berlin.de

To Enquiry

Note: Any losses due to technical changes and errors can not be accounted for 10/03